How to fix scratched up xbox 360 games

The answer is yes, if you install the game to the hard drive. If the disk is scratched, not working. Surface-level scratches can often be fixed using a substance like petroleum jelly Vaseline or toothpaste, though deeper scratches are impossible to fix. PSA: You can still install games even if your game disc is damaged by installing through the store. This only works if the Xbox One sees the game but stops the installation partway through.

Dry the disc with a lint-free cloth. Squeeze toothpaste on the disc. Rub the toothpaste on the disc in a straight motion not in a circular motion from the center to the outer edges. Wash off the toothpaste and dry the disc. Yes, toothpaste can remove minor paint scratches. A standard toothpaste not a gel toothpaste has a minor grit to it which helps buff out the scratches. Typically, minor scratches are only on the clear coat over your actual paint. Large circular scratches on a game disc are caused when the console is bumped or moved while in use.

To avoid this being accidentally done in the future, you might want to consider horizontal placement of the console if you are not already doing so. Here are a few methods to try to fix your scratched disc at home: Rubbing Alcohol Method: Get a lint free non scratching cloth. Let the bulb warm up for minutes. This will ensure that it is giving off enough heat to melt the outer layer. Hold up the "read" side of the disc 3 inches from the lamp.

Hold it close enough that you can feel the heat from the bulb. When holding the disc, only grip around the edges and insert a finger through the ring for support. Hold up to the lamp and rotate back and forth for about 20 seconds. If you hold the disc too long, you may permanently damage the disc.

It's better to pull it away too soon and try again than to hold it too long. Test out the disc. Take the disc from the lamp and immediately place it in your Xbox. Start up the console and see if your disc works.

If it still doesn't work, you may need to have the disc professionally resurfaced. Method 4. Purchase a Mr. Clean Magic Eraser. This cleaning tool can be found in most supermarkets. You may be able to find an off-brand version for cheaper as well.

Use the eraser to scrub the scratches. Make sure to scrub in straight lines from the center outwards. Apply a fair amount of force so that the eraser can polish the scratches, but not so much that it wears away the entire layer.

Rinse and dry the disc. After you've finished polishing the scratches with the magic eraser, run the disc under a water tap and dry it off with a soft cloth. When drying, use the same motion that you used to erase: straight lines from the center out to the edges. Try the disc. After you've finished polishing and rinsing the disc, you can try playing it again. If it still doesn't work, you can go another round with the magic eraser, or try another method from this article.

Method 5. Purchase a disc scratch repair tool. There are a variety of tools available online and at electronics retailers. One of the most popular products is the SkipDr, though there are several others available as well. Rinse and dry the disc before using the disc repair tool. Use warm water to rinse any debris and dust off of the disc, then dry it off with a microfiber cloth.

Most repair kits come with a soft cloth you can use. Spray the included cleaner fluid onto the "read" side of the disc. Don't spray it onto the label. Apply an even coat across the entire "read" side of the disc.

Insert the disc into the repair tool. The process for this will vary depending on the tool you are using. Make sure the "read" side is facing the scrubbing pad on the repair tool. Refer to the instructions to make sure you are inserting the disc properly. Press the mechanism to spin the disc in the repair tool. You may need to turn a crank or press a button to make the disc spin.

The repair tool will spin the disc, rubbing the cleaning pad across the "read" side. Buff the disc with the included buffing cloth. Many repair kits come with a buffing cloth, which you'll use to buff the disc after repairing it. Vigorous buffing will help ensure that the disc can be read.

Insert the repaired disc into your Xbox console and try playing it. If it still doesn't work, you can repeat the repair process again. Some users have reported it taking up to ten tries to get a game to work.

Some scratches may be too deep to repair using these tools. If the console is tilted or bumped during play, this can cause the disc to be scratched. Ensure that boisterous siblings or curious pets cannot get near the console while it is in use or whenever there is a disc inside. Not Helpful 22 Helpful Not Helpful 17 Helpful Try running the disc underneath warm water and use a wet cloth to gently wipe at the stains. Not Helpful 8 Helpful If none of these methods worked for you, you should probably think about getting a new one.

Not all scratches are repairable. Not Helpful 24 Helpful Just once; if you apply too much, it can damage the disc's surface. It should work for most of them, but some scratches are just beyond repair.

Not Helpful 18 Helpful Not Helpful 15 Helpful Use a lip balm without any colors, flavors, or glitter, or else it will damage your game.

Not Helpful 3 Helpful 8. Would toothpaste cleaning work on a DVD? Keep in mind that if the scratch is really bad, it may not be repairable.

Leave the toothpaste on for five minutes, then rinse off the toothpaste and dry. Using a soft, clean, slightly damp cloth, lightly wipe from the center of the disc outward. Do not use solvents to clean the disc. Simply take a cotton ball and dip it in some alcohol to clean the area near the scratch. Then apply Vaseline or Petroleum Jelly to the disc. The Vaseline will fill in the scratch, hopefully making it readable again.

Connect your Xbox to the internet with an Ethernet cable. Plug one end of the Ethernet cable into the back of your Xbox Insert the other end into your modem, gateway, or router.

Test your Xbox Live connection. Toothpaste can be used to repair scratches on a CD. Squeeze toothpaste onto the disc and rub it on the disc in a straight motion from the center out to the edges.

If the CD is badly scratched, repeat that process several times. Let it dry completely, then wash off the toothpaste, and carefully dry the disc. Start with a basic toothpaste, something natural without any fancy gels, swirls or flavors. Squeeze a small amount onto the CD starting at the middle radius and rub it in using a sweeping motion until the entire CD is covered in a light layer of toothpaste.