Taylor model c602 manual

Table of Contents. Model C Previous Page. Next Page. Page 2: Table Of Contents Model C Specifications. Page Page 5: Safety The many built-in safety features that non-flammable; however, any gas under pressure is are part of all Taylor equipment are aimed at potentially hazardous.

For example, if the refrigerant is lost during the course of ordinary The refrigeration compressor s on this machine are service to this machine, Taylor has no obligation to Failure to follow this the General Service Manual.

Model C Introduction Failure to follow this instruction may result in electrocution. Page Running Specifications Suction pressure equals expansion valve setting. See page 9 for the Refrigeration High side pressure varies for air cooled units, System Schematic.

The Auto mode will be locked out and the machine will be placed in the Standby mode. Model C Systems, Controls and Operations Page 14 To better communicate in the International arena, the words on many of our operator keys have been replaced by symbols to indicate their functions. The following chart identifies the symbol definitions. See Figure 8. See Figure 5. See Figure See page The soft serve side will continue operation in the mode it was in when the Menu was selected.

Increasing the time between heat cycles will cause Figure 29 the machine to soft lock if the start of the cycle does Model C Systems, Controls and Operations Replace the bad probe.

Page 26 3 displays the total time in each heat cycle phase. Page 27 Indicates the heat cycle was aborted in the Product Door Not in Place A product door is not in place or is loose.

When the glycol viscosity thickness. The Left Compressor Cycle Time is displayed first. See setting and advance to the Whitespot Setting for the Figure Select the return to the Service Menu. Page 34 - if the flow rate is too slow or the Menu screen and discontinue beater motor amount of syrup measured in the Verification Mode operation. Page 35 0.

Page Heat Treatment Graph 60 off. The timed cycle continues in this manner until minutes. Page Timers If the machine runs longer than 24 hours without a This pattern continues until hopper refrigeration is no successful Heat Treatment Cycle, the machine will longer required. Both freezer doors were removed concurrently.

The glycol existing in the accumulator The agitator is driven by a motor and belt s. Page 41 Replace the cap on the accumulator.

Replace the outlet Step 4 line of the glycol pump to proper position. Remove Check for glycol mixture leaks. To adjust the serving viscosity, it may be necessary to raise or lower the HD setting. Note: Be sure that the syrups are correctly calibrated before determining the proper serving viscosity.

Page Universal Control Uvc3 See table on page RAM Chip Stores program settings from menu in memory. Failure to follow these instructions may result. View online or download Taylor C Service Manual. Join Co-production practitioners network. Sign Up or Sign In. Powered by.

Badges Report an Issue Terms of Service. Co-production practitioners network A network for co-production practitioners. Blogs Forum. Co-production Email Dige. Description: 1" Black Nylon Brush. USD 3. Description: Double ended cleaning brush. Description: 1" White Nylon Brush. USD 9. Description: Large Tank brush. Description: 1 horsepower, Volt, Single phase beater motor. Item : Description: Blue Star Cap. Description: 1. This replacement motor was removed from a machine that we converted from 3 phase, to single phase.

In Stock. Description: Cogged Drive Belt Description: Replaces Taylor part USD 8. Description: Draw Switch. Description: Nut for Shell Bearing. Description: Guide Drip Seal. Description: Rear shell bearing for use in most Taylor Machines. Description: Taylor Drive Shaft. Description: Fan Relay for several Taylor air cooled soft serve machines.

Always In Stock - Ships Today! Description: Splash Shield C C